| General [main menu] | |
| Display Tool Tip Help | This will turn on the roll over tool tip help that shows pieces of information about parameters in the node management pages. |
| Reboot Now | Will cause the sytem to reboot immediately. |
| Settings Management | Save - will save the current setting in case they need to be restored at a later time. Restore - will recall the previously stored settings Qnode defaults - will apply the default Qcode settings that came from the factory |
| Update Active Mesh Node List | If you wish to update the active mesh node list immediately. |
| Reacquire Gateway | If the node is operating as a wireless node, this will cause the system to kill all back haul tunnels to reattempt a new virtual tunnel connection. |
| Check in with WIANA Now | If you are a registered node on the WIANA system you can force a checkin immediately with the WIANA system. |
| Disable WIANA checkin | If you want to prevent the node from ever attmetping to contact the WIANA system set this to Yes. It is useful in private networks without Internet access. |
| Lock Out WIANA Changes (To This Node Only) |
This will still allow the node checkin with the WIANA system but it will not allow any settings to be changed. The only way to change settings if this is enabled is via the web interface. |