|LAN/WAN (Interfaces) [main menu]|
|Node Operating Mode||Specify of this node will operate as a gateway or wireless repeater node.|
|Enable Ethernet Interface||
This will disable the ethernet interface if you don't want to enable ther ethernet port to gain access to the network.
If this is disabled, you will only be able to access the system wirelessly or via a connected console and keyboard directly to the unit.
DHCP (auto configure) will automatically set the system the specified address if the network is using DHCP configuration. This is the default setting.
Static IP (manual) will allow the user the specify the network information
|Ethernet IP Address||
IP addresses must be a public routable or 192.168.x.x address.
If the node is operating as a wireless node the system will default to 192.168.1.2 / 255.255.255.0 if nothing is specifed in the static IP system.
Note: as of Qcode 2.5 the system now allows 10.x.x.x with the exception of 10.253.253.x subnet which is used for the gateway mesh node internet connection system (wormholes)
|Ethernet Netmask||This will specify the network mask for the eth0 port.|
|Internet Gateway||This will specify the internet gateway address for the eth0 port if in gateway mode|
|Primary DNS||This will specify the primary DNS server for the eth0 port.|
|Secondary DNS||This will specify the secondary DNS server for the eth0 port.|
|Ethernet MAC Addrress||These are automatically determined and shown for your reference|
|Ethernet Connection Speed||These are automatically determined and shown for your reference|
Back to Top ++