| (Static Host) Network Address Translation & (Port Forwarding) Port Address Translation [main menu] |
|
| Enable NAT Mapping | NAT is a 1:1 mapping of a public IP on the gateway to an IP within the mesh. Set this to Yes if you want the NAT system available. |
| Local IP | This will be the public or extra available IP that will be mutli-hommed to this device. The gateway nodes can have multiple IP addresses assigned to the same interface. |
| Remote Cell ID | Use the cell ID of the remote node of your destination IP address. |
| Remote IP | This is the destination IP at the remote node. |
| Enable PAT Mapping | PAT is a port to port map and must be setup on the remote node and the local node. |
| Local Device | Specify the incoming interface to listen to |
| Local Port | Specify the incoming port to listen to |
| Remote IP | Specify the remote IP to redirect this traffic to |
| Remote Port(s) | Specify the remote port to redirect this traffic to |